ZC questions

morecarbonfiberthenu · Post by **morecarbonfiberthenu** » November 08, 2003

Does anyone know what parts from a d-series engine fit into a ZC engine? Can like pistons and rods vales and valve spings work in ZC from a d block? I know a lot of parts cross fit, but do the intenals swap too? I'm gonna start building one soon for my next project CRX.

Post by **DA 9_Chinga** » November 09, 2003

i dont know about anyone on this site but try http://www.passwordjdm.com or search google for d-series engine parts.
~Chinga

munster · Post by **munster** » November 09, 2003

I never did know much about ZCs. Try http://www.hondaswap.com or Hybrid Honda.

xxk0ssxx · Post by **xxk0ssxx** » November 09, 2003

as far as i know you can put ZC pistons in a D block so i would assume that u can put D pistons and rods in a ZC but y you would want to i don't know, ZC pistons and rods are a little more stronger than the D's, and about the valves.....i have not a clue

travis3265 · Post by **travis3265** » November 10, 2003

a ZC engine is a D-series motor. its a common misconception that its something totally different. most parts should be interchangeable like all other D-series motors are.

morecarbonfiberthenu · Post by **morecarbonfiberthenu** » November 12, 2003

Thanx i was pretty clear that the ZC was a d series but i had some doubt the parts were all interchangable...plus when i was speaking of swapping parts i mean better then stock ones to build the engine.

Post by **Nikku** » December 24, 2003

http://www.heeltoeauto.com/dseries/dseries1.html

piston info, what exactly are you trying to do?

thejdm.com v6 [2026 rebirth]

ZC questions

ZC questions

as far as i know...