Engine
• AEM Wideband EMS
• Motor built by Earl Laskey
• Benson Sleeved Block
• Crower Rods and Turbo Cams
• JG Cam Gears
• CP Pistons
• Balance Shaft Removal Kit
• Fluidampr Crank Pulley
• Z10 Motorsports Custom Oil Pan and Breather Kit
• Rocket Motor Sports Springs and Titanium Retainers
• ARP Head Studs
• Golden Eagle Intake Manifold
• STR throttle body 74mm
• RC 1000cc Injectors
• Marshall Shock Proof Fuel Pressure Gauge
• Hondata Intake Manifold Gasket
• Stainless Steel Turbo Manifold built by LoveFab, INC.
• Garrett GT35R Ball-bearing Turbo
• PWR Liquid to Air Barrel Intercooler 6x10
• 5gal. Fuel Cell for Water
• Aluminum 3" Intercooler Piping Custom Tig Welded
• Tial 50mm BOV and 40mm Wastegate
• Fluidyne Radiator
Transmission
• Omni Power Master Cylinder
• Competition Clutch Stage 6 Series Twin Disc Clutch (<50mi.)
• Stainless Steel 3" Exhaust Turbo Back
Suspension
• Omni Power Rear Lower Control Arms
• Omni Power Drag Full Body Coil-overs
• Energy Suspension Bushing Kit
• Energy Suspension Rear Trailing Arm Bushing Kit
Wheels
• Kosei K1 TS Whels
• 235/60/15 Mickey Thompson ET Street Radials (<50mi.)
• ARP Wheel Studs (front only)
• Skunk2 Magnesium Open Ended Lug Nuts (front only)
• Brakeman Rotors (all 4)
• Stainless Steel Lines
• GSR Front Brakes
• All Wheel Disk Brakes
Interior
• NEX Racing Seats
• Autometer gauges (Boost, A/F, Oil Pressure)
• Turbosmart E-Boost Electronic Boost Controller
• Apexi Turbo Timer
• Levoc Pedal Covers
• Power Windows All Work
Extras
• Pair of Omni Power Rear Street Coil-overs
• Pair of gutted doors
• Metal hood painted to match
Negatives
I want to make this sale as easy as possible and do not want the buyer to be disappointed so I’ll attempt to list anything I could see as a negative with the car.
Window Molding
There is no window molding around the windshield. Apparently when a new windshield was put on the car the guy changing it didn’t glue it in very well. I do have the moldings but haven’t tried to glue them in again.
No CD Player or Radio
The car doesn’t come with a CD player or radio. The harness is there and uncut though.
Autometer A/F Gauge not Reading Properly
The Autometer A/F gauge on the car isn’t set up for wideband so it doesn’t read now.
No Front Bumper Core
There is no front bumper core in the car. Clearance is a little tight with the intercooler and I haven’t tried to fit it. I do have the core and it goes with the car.
No Airbag Computer
The airbag computer was removed. The steering wheel does, however, have an airbag in it.
Hood & Trunk Cables
The hood cable is not hooked up to the hood puller. It is an easy pull on the cable to pop the hood.
Intercooler Water Lines Ran on Pass. Side Floor
The feed and return lines for the intercooler water are run on the passenger side floor. It doesn’t really cause a problem, I’d just like to mention it.
Door Locks
I have had issues with the door locks working in the past. Not sure why but I think I hooked up the metal rod to the handle incorrectly.
No Horn
The horns were removed.
Front Fenders Dented
The front fenders, though rolled, were dented by the tires. They aren’t too bad and I haven’t had the tires hit while I’ve owned it.
Carbon Fiber Hood Cracks Under Clear
The skin of the carbon fiber hood had flown off during a 1/4 pass. It had landed on the strip and remained in one piece. It has since been glued back on and hasn’t given any problems since. This is by far the lightest CF hood I’ve ever felt.
R Title
The car has an R-Title. I was some light front end sheet metal damage. I have some pics after the repair; however, I only saved the thumbnails. A close inspection of the car will show it was repaired properly.
That’s about all I can think of. Feel free to come see the car anytime. I'm asking $8,000.
